BULK BUY PRICE £252.00

Equivalent to £21 a can!

« Back

400ml of RESTORE is enough to treat approximately 2 litres of engine capacity or 4 litres of engine oil (calculated 10% RESTORE by volume to engine oil).  We are offering 12 cans (total 4.8 litres) at a special price - enough to treat twelve 2 litre cars or six tractors.

FOR CARS AND CLASSIC CARS - RESTORE is suitable for most 4-stroke engines*, whether petrol or diesel (even dual-fuelled and lpg) or turbo-charged, and has no adverse effect on catalytic converters as it does not enter the combustion cycle.

RESTORE is a life-saver for worn, tired and smoky engines and will balance out compression across the cylinders even in newer engines. It reduces engine noise and has even been known to cure fledgling bottom-end knock. All used engines, but particularly those that have clocked up more than 40,000 miles, will benefit from the use of RESTORE - after treatment you will notice less smoke, less oil-burn, fewer start-up problems and the engine will run smoother and quieter.  You could save a fortune in engine repairs and replacement parts and keep your car running longer and more reliably.

Used in accordance with the instructions supplied AMETECH RESTORE Engine Restorer and Lubricant has the ability to:

Cure Blue Smoke and exhaust emissions   *   Restore Compression   *   Reduce Oil Consumption   *   Restore Horsepower and Torque   *   Improve MPG   *   Improve cold starting ability   *    Prolong Engine Life<   *   Contribute towards reducing Global Warming by reducing CO emissions  and extending the useable life of old engines   *   Repair fishing boat engines and tractor engines without any downtime.  

An EP (extreme pressure) lubricant in its own right, RESTORE just needs a standard motor oil to act as a carrier for it in your engine - not friction reducing oils, as these will just repel RESTORE's CSL particles, preventing them from reaching the worn metalwork in the engine. RESTORE can also be used in MANUAL gearboxes, where it is helpful in reducing whine by reversing wear in the bronze bearings and reducing 'back-lash' by re-aligning the gears. Do not use it in automatic gearboxes; we have another product called Metal-Tec10 which reduces friction and heat in automatic gearboxes, smoothing out the metal and reducing whine.

Ametech® Engine RESTORE Oil is suitable for use in all four stroke petrol and diesel engines, with the exception of HEUI engines (hydraulically actuated electronic unit injection diesel engines), VVT-Li engines (VVT Lift-intelligent), VTec and iVTec engines, Vanos, Double Vanos and ACVS systems; all these engines utilise oil pressure to actuate other engine functions and therefore do not tolerate particles in oil.

RESTORE is safe to use in standard dual-fuelled and lpg engines, most VVT and VVTi engines and engines with turbo-chargers and catalytic converters. RESTORE should not be used in wet clutch environments or in a Petroil mix. (Please read our FREQUENTLY ASKED QUESTIONS for more information on use of RESTORE in different types of engines and situations).

One 400ml can of RESTORE will treat 1.5 to 2.0 litres of engine size. Order multiples of this size of can for each 2000cc of engine size you wish to treat. For best results, add to a clean engine with fresh oil and filter. Just shake it up and pour it in!

This size of can has a ring-pull opening (similar to a Coca-Cola can) so cannot be re-sealed once opened. It is important to shake the can well before using to agitate the CSL particles. If you are not using a full 400ml can in one application we suggest you transfer the remaining oil to a container with a sealed top (preferably not plastic), label it clearly as to its contents, and keep it out of the reach of children for future use.

*FOR MORE INFORMATION GO TO OUR FREQUENTLY ASKED QUESTIONS page.