Engine Flush|Motor Cleaner

Engine flush | Engine cleaner | Motor cleaner | Engine sludge remover

Over time, many engines become contaminated with sludge, varnishes, gums and carbon, which coat the pistons, cylinder walls and bearings and can block oil-ways, causing low oil pressure and in extreme cases engine failure. Cleaning your engine once in a while with a mild flushing agent, added to the old oil, will release the sludge and dissolve the varnishes and gums which can then be flushed from the engine when you drain the sump and discard the old oil filter.  You will probably be surprised by the filth that comes out of your engine. 

Ametech RESTORE Motor Cleaner is specially formulated to be easy to use. It contains lubricants to protect your engine, while the flushing agents (one of which is Kerosene - highly effective as an oil dispersant and cleaner) do their work.  Put it in the engine with the existing engine oil and run the engine with the car stationary for 15 minutes - that's all it takes.  After thoroughly draining the sump you are ready to refill with fresh oil and renew the oil filter and away you go.  You'll find your engine oil stays cleaner for much longer.

Add a can of Ametech RESTORE Engine Restorer and Lubricant to reverse engine wear by filling in the scratches and wear exposed following the cleaning process and see your engine gradually come back to life.

Sort by:

View

Showing 1 - 1 of 1 products
Showing 1 - 1 of 1 products

Add to old engine oil before an oil change and run the engine for 10-15 minutes to free the engine sump and oil-ways of harmful sludge, varnishes and gums and free up sticking rings and tappets. Keeps new oil clean for longer. Add one 250ml bottle to 3 to 6 litres of oil in the sump before oil change.